This is a new Samsung replacement battery to fit certain electric screwdrivers and powertools that use a single Lithium-ion battery, such as those from Bosch, Ryobi and Black and Decker (B+D).
This upgrade rechargeable battery is higher capacity than the original one fitted to your powertool so it will run for longer between charge-ups. Your original battery will be between 1300mAh and 2200mAh capacity. This 2500mAh battery is fitted with long, 5mm-wide solder tags designed for easy fitment and soldering. The solder tags need to be folded and trimmed to the same shape and length as the tags on your original battery.
These are genuine, high-output Samsung batteries of suitable specification to charge and run correctly in your Li-ion powertool. Your original battery voltage will be rated somewhere between 3.6V and 4V. This is a nominal manufacturer rating and the actual voltage varies with state of charge. All Li-ion batteries rated in this range will charge up to around 4.2V when full and then run down as low as 3.0V when empty.
Compatible with Li-ion versions of the following powertools, and others:
- Black+Decker screwdriver including:
- some AS36LN, BDCS36G, CS3651LC, CS3653LC, KC36LN models
- Bosch IXO screwdriver
- Bosch ISIO trimmer
- Bosch CISO secateur
- Bosch XEO cutter
- Bosch PTK 3.6 LI tacker
- Bosch PSR Select
- Ryobi CSD screwdriver (not 480 version)
- Ryobi BSH
Lithium-ion batteries can ignite if short-circuited so great care must be taken when handling and fitting to avoid short-circuits. Seek professional guidance. Not suitable for replacing Ni-Cd or Ni-MH batteries.
- Length: 65mm (suitable for replacing 64mm, 65mm, 66mm and 67mm long batteries)
- Diameter: 18mm
- Voltage: 3.6V
- Typical Capacity: 2500mAh
- Chemistry: Lithium-ion (Li-ion)
- Maximum continuous current: 20A
- Brand: Samsung
- Fitted with 5mm-wide solder tags at both ends for easy installation and soldering
It is strongly recommended that you open up your powertool before ordering to double-check the battery measurements.
You must be competent at soldering to fit this replacement and the fitted tags will need trimming with scissors to suit your powertool.